Search results

there is a nos mwo kit on ebay now, somebody get the kit, then make up the bracket, reprint the instuctions, ect. for the rest of us

at the fuel filter, there are TWO petcocks, one is the water drain at the bottom of the filter, one if just before the filter on the tank side, make sure these are tight, thay may be tight but have crud in them (especialy the bottom of the filter one) where thay dont leak fuel but will leak...

what is the total head and vehicile count for the rally

WOW, just WOW

the m62 is in 1/32

RE: Re: RE: I have been looking for this kit.. i looked at that kit but it is in 1/32 not 1/35, you can get a 1/35 resin wrecker kit that uses the 900 series cargo as the starting point

the tm calls for a 3 peice pushrod, i made a 1 peice, i mounted two brackets on the spare tire side of the boom that my pushrod fits in

the tm calls for a push rod between main boom and the tip, there is two brackets that the push rod fit in, you pull the tip pins, extent out the powered boom, place the push rod in the brackets, then retract the powered section, as this goes in the unpowered section is pushed out, keep...

5ts have 6.44

i do 1/35 , 1/87, 1/1 scale, in the 1/35 heavy transport, bridging, a lot still in the box, in 1/87 i have about 100 or so, heavy transport, engineering, bridging, recovery, fuel transport, special support vehicles, in 1/1 a m819 and a xm977

i think you mean the air pressure governor, thay are cheap, get a new one from a big truck parts house, the governor gets gumed up and stick or the o-rings leak and crack

i believe a timkin dd series double reduction drop in third member will fit our 5t rears, (just finding them that would be the problem) then swapping our 6.44 gears to it, timkin also made a smaller version that looks like the deuce axles, both of these timkins had a power divider (a inter...

never mind, i found it, sometimes new is not better

with the new page format, how do you LOG OFF

i spliced packard connectors in place of the plug on the light bar, made Ys where needed

my old m52 gasser was in better shape then some of the stuff we ran in v.n.

i made my own cable useing a 105 harness and 7 wire trailer cable from napa, make it what ever length you want, to long is better then to short

on tex farm road 2802 (this goes from tex fr 62 in the east to tx fr 105 at the west end) i spotted three 5t dumps, 1 is a 817, the other two are m52a2s, the 817 has a smashed up right front corner, the bed is off but there, one 51 start and runs good, the owner (yes i talked to the owner this...

update i had a chance to go check out the dump today, it is a 66 342a2 deuce dump, no rad., missing right front window, over all it is in not to bad condition, has pipe welded in the bed, no tail gate, supposed to run and stop good, was gotten from a local contractor after thay poked a hole...

is both sides working loose or just one side