Search results

I recently had the same problem.. That key snapped in half. Hummer parts guy didn't have it, but Kascar did.

Thank you! It's been a long process, and it's the first time I've ever painted a truck. Good thing matte paint is forgiving! I need to post up some pics of the whole thing. Still has a long way to go, but it's back on the road, and I'm having fun with it.

Ok, here are a few pics of what I did. I wrapped the cables in that twisty cable protection stuff (that's a technical term... I looked it up!) and just routed them over the transmission, and to where I put the switch. After drilling the hole for the switch, I noticed that I went through a seam...

I can't remember exactly, I think it was 7' and I had a little extra I used to make a new battery cable I needed. I'll snap a couple of pics underneath the truck tomorrow to show how I routed it. In their previous post Those Military Guys said they would have a kit for installing in both...

Here is where I put mine.purchased from those Military Guys.

I'm doing something similar for my 4 man. I'll post some pics when I get out to my shop.

My '87 m1038 doesn't have the cooler. I bought the kit, and will be installing it soon. My gearbox is leaking pretty bad. I was going to order new inlet and outlet seals and see if that fixes the problem. I talked to Hummer Parts Guy a while back, and if I remember correctly a new gear box is...

Loving those Safari doors! Are you planning on mass producing them??! I've been working on a 1987 M1038, but your project seems to be moving along much faster than mine!

I was planning on calling you guys about the battery cut off.. Hopefully someone close to you with a hmmwv can let you take some measurements. I'll call Monday or Tuesday to order several things.

Where did you install the keyed battery disconnect? I'm wanting to install one in a "not so obvious" place, so the dash will still look original.

great advice... I wish I had followed it when I did my install! Yes, I had to oversize the mounting holes quite a bit to get mine to fit.

Thanks Metalman, I think I remember this discussion on the G. I'm actually looking for the brackets for a sponson panel... I'm still a noob, figuring out what all the parts correct names should be. my hmmwv is a 4 man soft top, but I'm installing a sponson panel to keep stuff from sliding into...

Did anyone take you up on the offer?? I was still planning on making my own, but I'd rather have an exact match. Unfortunately I don't have a set to send you.

Bummer! Sounds like fun.

So.... What about next Saturday? I'm going to try and get paint on my truck next week and if (that's a huge "if") I get it done in time, I might drive up. I'm assuming its the Cabela's in Eugene, right? What time, what's the plan? Thanks! Paul D

I need 2 of these too...

Are HMMWV's chain covers supposed to be canvas? I have only seen them in rubber...

Good to know... I have never seen shrink wrap that big before.... Where could I find it? Thanks, Paul D

Are canvas covers OEM for HMMWVs? I've only seen the rubber covers. Mine are beyond restoration... cracked, torn, and painted tan. Thank you for the info! Paul D

Great idea!! I really should know this (I used to be a bike nerd - but then again, Road bike & mountain bike, I've never had a hybrid) What size tire/tube do hybrid bikes use?