Search results

I purchased a mighty 2d diesel injection cleaning kit from a local auto shop in my town. I decided to put the hose down the pipe leading to the turbo, since I didn't want to replace the gasket leading to the intake manifold from the turbo. I throttled up the duece and sparayed the entire can...

Does anyone know what the backspace is on both side's of mike's wheel's? Has anyone lad their rim down and measured it? if so, could you please post your result's.

Does anyone know who, or where i can find the hub flip pics that someone posted on here a long time ago? I have searched for 2 hours looking for it. I thought they were in the resources pages, but all I can fid there is the drawing someone put together. Someone on here posted step by step...

Hello guys, it appears as though I have been driving for A few months with as crack in the inlet of my fdc. I realised it when it got so bad that diesel was spraying all over everywhere! does anyone have, or know where I can get a new fdc? My truck had just been decomissioned from the military...

I'm replacing the alternator on my M35A2. There is the exciter wire coming from the main switch, a thick wire that goes to A big post, then there is also A small post, next to the big post. Does something go to this small post? when I took my warning cover off, there was nothing going to the...

i have searched for engine swap forums on here and have come up with little to nothing. i know the m32a3 comes with a caterpillar 3116 engine, but does anyone know of another type of diesel that would bolt up to the duece's 5 speed transmission? i was looking at the cat 3406e engine, however i...

i had read on an earlier thread somewhere that there was someone worried about his injectors coking. has anyone considered a filter heater such as this one ebay? this one even has the relay already attatched, wired and ready to go! http://shortlinks.net/akw845 (ebay link) p.s. sasquatch santa...

i have been searching for 2 hours for a thread that someone posted. i wanted to say maybe it was sasquatch santa. im wrong more than likely, however i specifically remember in the thread they posted how much horepower the ldt-465 engine would produce with a certain pressure of fuel being...

I was wondering if their is a difference in the wheels between the m35 dually versus the m34 super single. I know on the m34 they come with 11.00X20 tire, so is the rim wider than the m35's 9.00x20 tire? Is the offset of the wheel the same, or is the weel width and offset the same on both...

does anyone know a source on where to get tractor wheels with the rockwell pattern center already welded? thinking about some r1's for mud use. right now i have some 385/65r22.5 retreads with a grader/skid steer tread on them mounted on 14x22.5 inch accuride wheels. not as aggressive as the r1...

hello, does anyone know what the length and diameter of the knurled end of the duece's main stud. i know the threaded end is 3/4 of course. i have access to some old truck studs and was wondering if they would fit without having to knock one out. also i see a few people upgrading to the 16X20...

Does Anyone Know If The 5 Ton !0 Lug Bolt Pattern Is The Same As Commercial Civilian 18 Wheelers And Dump Trucks? which is 10 on 11.25