Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
Not sure what these are used for. Did not see anything like this when I removed heads from motor on multifuel. Also, I was able to remove the nuts from oil cooler side. I am not sure the tool I have will be able to torque nuts. Is anyone willing to loan or rent their tool. If so, please...
I have a M35 Deuce and half with the Hercules engine. Recently I had a stuck injector and had it fixed and reinstalled. Truck runs very rough still and smokes. I am getting out of my scope of expertise and looking for a mechanic or shop to look at the problem. I live in the Raleigh NC area...
I did not have a crane so I had to use the poor man's method of lifting beds off of deuces to swap out. I wanted to post pictures for everyones enjoyment.
Hello steelsoldiers,
I finally have cleared the EUC hurdle. I will be traveling to Forest Park GA from Raleigh NC to pick up my new deuce. I thought it might be a good idea to have some contacts along the route in case of any trouble. I will be leaving Raleigh Wed evening (10/7/09) and...
Switched from c code 6.2 diesel in a k10 to a military 6.2 hummer engine. Had to switch over many parts (intake manifold, brackets, exhaust headers, fuel solenoid, etc.) When started it up noticed a lot of black dark smoke from unburnt fuel. I have turned down the fuel slightly to correct...
Does anyone know where to purchase a 12 volt fuel shut off solenoid? It is the solenoid that is inside the injector pump top cap. I bought a military 6.2 engine and putting it in a civilian truck. The pump has a 24 volt solenoid currently and will not work off of 12 volts. I tried local...
Okay, I removed the propeller shaft, transmission, pressure plate and clutch. Now, my question is how do I remove the pilot bearing? Do I have to remove the flywheel to replace it or can I replace the pilot bearing with flywheel in place on the m35a2. Is there any kind of special tool that I...
Okay, I hope I do not make this to confusing.
This is the situation I have...
When I apply brakes both brake lights come on. If I use the right turn signal the right brake light flashes and left light stays on with brakes still applied. Here is where the problem is. When I use the left...
I noticed yesterday my brake lights not working correctly. I checked bulbs and they are ok. I noticed that if you hold down brake pedal for about 2-3 minutes they sometimes will come on either full strength or dim then go full strength. I checked wires that go to master cylinder. When you...
I purchased a M35a2 from GL last month. The data plate says manufacture is Jeep Kaiser and the invoice I got says AM General. This personally does not bother me. The only problem I am concerned about is in NC I have to have the vehicle inspected by a DMV enforcement officer. I am worried they...
I just bought a deuce. I want to install a hitch to tow a trailer. The one issue I have is how to correctly hook up a trailer wire connection. How do I get the 24v signals coming off brake lights, turn signals, running lights etc. to run a 12v system on a trailer. The goal is to be able to...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!