-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Recent content by rnd-motorsports
-
New Member Intro - Ya'all have been great so far!
Welcome from central Michigan!- rnd-motorsports
- Post #13
- Forum: Requirements For New Members
-
What is it and why did it smoke.
Well for starters its a 24 volt you need a 12 volt!- rnd-motorsports
- Post #30
- Forum: CUCV
-
thinking about doing black white and grey camo
Remember to keep the pics up here when ur done!- rnd-motorsports
- Post #52
- Forum: CUCV
-
Replace or Rebuild M1028 axle?
Not that you do not know ( you would be surprised how many don't ) make sure if you get a replacement make sure the gears are the same as what came out stock should be 4:56 unless somebody changed it at some point just be sure to check! will not be good if has been changed at some point. Just to...- rnd-motorsports
- Post #10
- Forum: CUCV
-
Oil Pan gasket replacement
As stated fel-pro os34400 or victor os30591- rnd-motorsports
- Post #35
- Forum: CUCV
-
Oil Pan gasket replacement
I prefer felpro myself but both work. stay away from the cheaper gaskets imo.- rnd-motorsports
- Post #33
- Forum: CUCV
-
Where can I buy Cucv Bed Mounting bolts?
As gungears stated you local hardware grade 8 best grade 5 good not a specail bolt if not there lowes,home depot, menards and you local parts store!- rnd-motorsports
- Post #5
- Forum: CUCV
-
-
Introducing Smokey
Nice truck!! Only thing that would be better then a m1008 is a nice m1028- rnd-motorsports
- Post #17
- Forum: CUCV
-
Rear Axle (Gov Locker)
They are a diff animal ! but work great !- rnd-motorsports
- Post #14
- Forum: CUCV
-
-
M1009 rear noise
I would check the bearings! are you shur the noise is from the rear axle?- rnd-motorsports
- Post #2
- Forum: CUCV
-
New CUCV owner - Transmission and engine questions
Welcome to the forum! looks like somebody did a lot of work on that truck ! once you get warm weather the fun can start! good luck on getting it going again!![thumbzup]- rnd-motorsports
- Post #21
- Forum: CUCV
-
My final m1028 project
Got to be the best looking truck have seen in a while!!! :beer: Great job can't wait to see it done!- rnd-motorsports
- Post #58
- Forum: CUCV
-
My M1008 ORD 4" Lift w/37's
Nice lookin truck ! Good job! [thumbzup]- rnd-motorsports
- Post #19
- Forum: CUCV