Search results

Where the heck is this vac line supos to go i was working on timing the m1028 and found that somone just threaded a bolt in the end.

Any noticeable difference after the 40 hp injectors were installed?:jumpin::jumpin:

The video said you can stick it in your dishwasher to clean it :roll....

aua I have never tryed them...dont be surprized if you get your wiener smacked for posting ebay ad

I just replaced my wellmans with ac60s in january and have had no problems..I was in a hurry so i just ground down the tabs but like many others have stated its a good idea to change to the proper size terminals. wich is what i am about to do now

Well according to the gear ratio calculator with my tranny and tc and tire size @ 65 mph in 4th gear rpm is @ 2123 @ 75 mph rpm is @ 2450 Sounds a little off to me but i will know for sure when i install my tach next week i will post results

I just checked speedo says im doing 65 gps says im doing 67

Bfgoodrich 285-75 r16

Im getting 22 mpg @ 65 mph. I havent installed my tach yet but id say its around 1800 2000 range

[thumbzup] awsome thanks guys [thumbzup]

my tranny guy just put the 700r4 in my 1028 but he didnt adjust the transfer case linkage,so my transfer case was in 4 high and the hubs were not locked. Not knowing this i drove it down the highway about 30 mile @ 70 mph. According to him my transfer case did not get damaged. Is there anything...

bushhawg73 how much gear oil should i put in I would check the manuals but they are down.do you use additive for the locker is so what kind rosco yes i cleaned it all up and added new bearing grease. the seal looks brand new

Thanks Glen I checked the tires are eaqual hight and psi. I pulled the cover plate and found metal shavings and chunks on the magnet, i thought metal shavings is bad but the guy at the auto store said its normal? ( what kind of gearoil and additive do i put in the 14 corporate?)

well i pulled the axle and the end nut was infact loose so i tightened it up put everything together and took it for a spin...seams to run ok but i notice that when i am coming to a stop it clanks...since i just did the 700r4 upgrade i thought it might have something to do with that or slop in...

thanks for the quick answers guys. ignore my last question i didnt see your response roller

lol i was gonna say...:-)... so i probably shouldnt drive it 65 miles to work tomorrow ? what do you think it might be...? (wheel bearing )

I have a question about my m1028 rear axle..my rear passanger tire moves in an out.when i jack the rear end up and push the tire it slides in about a 1/8 inchI looked under and the drum is moving with the tire...(lugs are tight ) my rear driver side tire does not do this...would this be a bad...

Sorry about the late reply im on vacation and have been sleeping in late. The smoking in my truck I think was just from the metal heating up more due to the new style glow plugs. After turning my key on it now takes about 10 seconds for the light to shut off and another 15 seconds for the...

when my truck is idleing i have allways had a vibration inside my cab. this morning coming home from work, i was at a stop sign and the vibration got real bad. kinda sounded like i was driving on a rumble strip...i gave it a little gas and the vibration goes away,but when it just idles it...

Can i remove the air filter and dump a little bit of diesel in the intake?