Search results

I will need some new rear door weather strip as well. Could you please post the McMaster P/N for the material you used? Thanks.

I removed the engine out of my M1010 for a rebuild, when I removed the starter, I noticed the high current wire connection on the starter looked odd. After removing the B+ wire from the starter, it appeared that at one time this connection became extremely hot. Another example that high current...

Engine has been removed.

The truck will get converted to 12VDC, so I may run larger wires to the rear of the vehicle.

Sure!!! Bring it up and we can have it off in a day...

Yes, finally a shop that I can call my own!!

Finally, started the tear down of my M1010. I bought this truck years ago for use on the MVPA Convoys. Well, 8 years later, I am finally getting the chance to do that. Hopefully, I will have it completed by the next Convoy in October 2024. Plans are to refurbish the entire vehicle, delete...

Go to Harrisburg and use the walk in service center. I was able to resolve my Historic MV tag issue in a short time. The person I dealt with really knew her job and exactly how to correct the issue. Penn DOT Locations Harrisburg Riverfront Office Center Address: 1101 S. Front St., Harrisburg...

Also check the splices on the fusible links near the 12v diamond shaped junction on the firewall. Tug and pull on them a little to ensure that they are still in good shape. Sometimes they will become intermittent and cause the same issue you experienced.

Call OFI, ask and see if there is anyway they could get you an IP by Thanksgiving. It's worth a phone call. You can send a core back to them after you have received the new IP.

I have purchased IP's from Oregon Fuel Injection 3 or 4 times. No issues with them.

Start your own car wash....

It looks very nice. Curious as to what part of the new dash needed trimming to make it fit correctly?

Dash Pad Pictures of the the one I purchased from Top Flight in Reedsville, PA It is the Medium Grey version, but I have purchased the Black ones as well.

I believe it was around $ 250. I puchased and installed it 3 years ago.

Here are a few pictures of my Top Flight dash board. Not exactly sure which on it is. I think it's the Top Flight - GM82014 Very nice product, I drive over and pick them up at the retail outlet in Reedsville, PA.

Those are noise suppression capacitors, they are not normally needed unless you have radio equipment installed. Unplug them and plug them and plug the truck harness directly to the wiper motor.

Hello and Welcome to the site. I am sure that a few members will be able to help you with your questions on MA registration and license requirements. One suggestion, typing in all capital letters is frowned upon here. Take care, I hope you enjoy the site and your MV!

This is the Convoy that you heard of. The Northwest Parks Convoy (NWP’22) was postponed in 2020 due to the Covid-19 pandemic and has been rescheduled for August 2022. The convoy will be traveling through Idaho, Washington and Oregon starting August 14, 2022 in Kamiah, Idaho with a round...

I have used KBS products on antennas, so far no issues. Painted 102" and many other smaller antenna whips with this: KBS Top Coat It is available in Flat Black, OD green, Camo Brown and Desert Tan. I have painted 2 vehicles with it as well. So far it has been a good choice. I prepped the whips...