Search results

My garage door is a few inches to long to let me back the deuce in without removing the stack. I just clear without the cab top off. Might actually make it with the cab top on too, but haven't tried yet. I'm considering chopping off a couple inches of the stack, maybe flat, maybe angled like...

Found a '52 GMC M211 near Somerset Pa. That's about 3 hours from me and I don't have means of transporting it home to Hershey or know if I want to get into an older gas powered deuce. Now that my m35 is done I'm really liking the multifuel. Don't know much about the earlier models. Looks like...

I finally got my deuce done and ready for the road. Plates came yesterday. I went to put the wipers on since I've had them off since tearing everything done. Noticed the knurled cap and the screw to hold it on are missing from the end of the wiper shaft. I have the upgrade kit I bought from OD...

I'm running into problems with the PA DMV. They won't except the pictures of my deuce for antique registration because I don't have a soft top top put on it and I don't have time or funds to get one right now. Just have my beat up frame and part of a top. Other than that my deuce is mint with...

Getting the deuce back together and ran into some trouble with the wiring. I bought a new harness from od iron. Everything matches up except where the wiring comes through the firewall there are two wires (74a and 74b) that were not on the original harness. We left them unhooked. Everything...

I haven't seen this vehicle mentioned anywhere on the site. Too bad it will probably never go into production. I would buy one in a split second. What's everyones opinion? Jeep Nukizer 715 The Jeep Nukizer 715 is an all-purpose truck that pays homage to the beloved military-only Kaiser...

Has anyone built any type of skid plates for the deuce? Front, rear, under batts, under tool box, whatever... I've used the search but didn't find too much. Are skid plates even worth while since there is so much clearance. I'd like to see some pics to get ideas for what could be added. My...

signature test

I've been browsing for an M37 for my father in law. Ive got the green fever and figure I might as well pass it on. He would love to get an M37 but I don't see his wife letting him spend 5 grand or more on a ready to go truck. I'd like to find something in decent shape that we could work on...

The deuce is finally titled, registered, and insured. So, I started disassembling her this past week. I've got about three days in it so far. The plan was to do a decent clean up and sand down for paint. Now it looks like I'm going to go a little deeper. The old bed had some small spots of...

I bought a deuce last month and have been getting ready to overhaul it this winter. The garage is cleaned out and ready to go. My brother is delivering a 5 ton gantry lift tomorrow. Should make lifting the heavy stuff much easier. (the engine lift worked for pulling the tranny right after I...

I've been lurking here for awhile now and found a truck with help from a few members. Ended up buying a '70 M35A2 from zb39 this past Sunday. Attempted to drive the truck from western PA near Slippery Rock to central PA in Lancaster County. Got about 40-50 miles with everything going well...

Just saying hi and wanted to thank the members here on SS. I've always wanted an old MV but it never seemed like a good time to buy one. Decided to just go ahead and do it. Bought a truck from zb39 here on SS this past Sunday. Had some problems with the drive across PA, but now it's home and...

I've been lurking on SS for awhile now and have been reading up on Deuces. I'm finally ready to make a purchase as soon as I find a decent deal in Central or Southern PA. I'd like to find something in driveable condition. Planning to use it for hauling atvs/tractor, occasional 4 wheeling...