Search results

This is the second failure of the transfer case adapter mount I have had. Can anyone give me ideas on what and where to look for the problem. All LOOKS good but there has got to be something else wrong. And also where to find another.

86 CUCV "stock" with the exception of doghead starter relay mod and GP controller card bypass, has ran fine for years but here lately has been stalling, only when cold and only after a sudden rpm change. Such as when fast idle kicks off, quick mash of fuel pedal and when stopping. And only...

Can someone give me the estimated cost of a brake job on a 1028? Going to redo lines and completely replace front and rear. Need an idea before I approach my finace manager... AKA wife.

Can anyone give me any information on these? They were mounted to the firewall behind the air intake.

I was told that my transmission mount/crossmember was bent, that it should be at leat 13/16 higher on the ends than in the middle. Mine is about that on the drivers side but almost even with the middle on the passenger side. I need to know if what I was told was accurate. I cant find a full...

My adapter is cracked. Cracked so badly I think the transfer case will fall. Thereal issue is where to find one. Any suggestions?

Need some thoughts here. If you have a loose battery terminal and when it starts it sounds like a weak battery. Had this problem about a week. Got up this morning to start it and it just clicks, sounds like a dead battery. Switched the batteries and still the same. I am thinking poor...

I replaced the fluid in the transfer case. Added 5 quarts. Now there is a leak coming from a small hole at the top just below the (what i believe to be) the speedometer cable. The hole looks factory but I dont know Any suggestions?

I got the blackout light fixed, the front main running light(the light in the grill). I removed the original housing and replaced with a fog light I had. I was looking for other opinions on color. Would you go back with white light or use another other color.

I got a leak that seems to be coming from the top of the transmission. Any ideas what or where it could be from. Thanks in advance for any help.

What are some symptoms that your GPR might be beginning to fail?

At the front of the motor next to ilde adjustment there is a rubber female fitting with tow plugs placed vertically. At least for sure there is one vacuum line that plugs in not sure what the other line does but i assume i leads to the transmission due to length of line and the problems i am...

Changed oil today overfilled funnel oil spilled onto passenger side ALT. after cleaning up what i could i had to move the truck. now the gen light stays for a good 45 seconds where as before it would go out only a second or two after started. any suggestions.. on a side note what...

Both are ISO grnd? Been told only passenger side is. If this is so then the passendger side can only be ISO grnd if replaced. Can a ISO grnd be used for the driver side? As for a starter could a 12v starter be used with the current electrical system by installing disconnects in the battery...

What are the parts for these CUCV's that are getting the hardest to find. I just got my 1028 a month ago and I want to go ahead and stock up on parts especially the hard to find ones.

What would be the top spare parts I should get for an 86 1028.

How free should the front wheels spin on the front axle with one side jacked up. I just put newer tires on my 1028 the front hubs seemed to be tight. they didnt spin as free as i thought they should. this is my first 4 wheel drive so i am not sure how these axles are supposed to behave.

how long should the gen 2 light stay on after starting. mine comes on but as soon as i idle it up it goes and doesnt come back on. until the next start

Tell me if this is normal or not. When i start the truck(1028) the volt meter goes to green and then slowly falls back to yellow then i hear a click in the dash as descrbie above the needle climbs back to green and never waivers.

Does anyone have recomendations on how to or not to remove the radio plug under the dash on a 86 1028. I was wanting to use that area for a CB mount and hopefully get rid of that plug or maybe us power from it for the CB.