Search results

Looking for some advice/help converting my m1010 to 12 volt charging system. My duvac went haywire overcharging the front battery. Already sourced leece Neville 12 volt alternator . Need some help with what wires to keep . Can't find wiring diagram anywhere I look. Thanks in advance. Sent from...

My m1010 smokes white when running. But wont stay running long enough to warm up.43000 miles on it no loss of coolant. And no signs of coolant in oil.any suggestions where to start looking.

My 1985 m1010 starts but won't idle.It won't Rev but I can keep it running. I was driving up a hill when I lost power. Checked for a blocked fuel filter it's getting plenty of fuel. Any ideas about what to check would be greatly appreciated. Thank you Rick

wiring issue. started with dash gauges not working now no power to dash.any help with schematics would be greatly appreciatedthanks in advance

Can anyone tell me what size fuel tank is in my 1985 m1010. Thank you in advance.

Filter housing is leaking and fuel preheated not working. What is my best way to fix?I understand this is a common problem. Any input would be helpful. Thank you.

I don't think my glow plugs are heating up. I have power to them but won't start without starting fluid. Had no issues last year. My question is will autolite 1110 glow plugs work without modification other than the spade connectors? Thanks in advance.

I have what I assume to be a bad cold start board on my 85 m1010 6.2 can anyone help with manual glow plug control conversion thank you in advance

My m1010 is leaking fuel from behind the filter replaced the housing and the filter. leak stopped for about 6 hours now as bad or worse than before change. had to reuse switch fuel heater and filter sensor .heater is broke but not leaking I think it may be the pressure switch any clue where I...

Hi I need some information please. fuel injector return hoses are rotting off .l can't find out what type of rubber line to use and what size. called all local auto parts and diesel repair shops nobody can help .hope someone here can thanks in advance.

I only have low speed how do I test to see if switch is working

alternators charging runs fine 24 volt 200 amp shut it down and leave it dead batteries in 24 hours