Search results

Does anyone know of a good way to support the cable that pulls the gear selector on the steering column / dash? The plastic piece that holds the wire broke off. I tried JB weld to hold the plastic piece that broke off, and it wasn't strong enough. Could you screw in a small bolt to let the...

Could someone tell me if it matters which wires are connected on the rear black-out lights? There is a two-wire harness on the vehicle (green and black), and there are two wires on the black-out light. One of the wires on the blackout light has metal clips with the part number. Does it...

Could someone tell me where this gray wire is supposed to be connected (pictured with blue glove holding it)? It looks like it goes to the heater switch or volt meter? The second picture shows the red power wire it was spliced in to (I think???) by the previous owner. Any ideas what it was...

I did the Doghead starter relay mod and the glow plug momentary button on my 85 m1009. when I turned the key, it had power. The glow plug momentary button worked. Then I went to start it, and all the power shut off. Now it is completely dead. Batteries are hooked up tight with plenty of...

My brake lights work, and rear blinkers work. But when the left blinker is on and then I step on the brake, both lights go out. Any help would be appreciated. Thank you!

I replaced the oil pressure gage and transducer on a 1993 Humvee with 6.5L GEP (transducer and Gauge were bad). When startting cold, the oil pressure is reading 45. When it gets hot the pressure gets much lower (around zero) and fluctuates. Tempuratrue is around 200 when revving it hard in...

Does anyone have any suggestions on how to fill four holes that were drilled completely through (daylight shining through) the roof of an m1009 above the driver's head? I am going to paint it next week. A fire department mounted lights previously. Also, what do you fill the holes in the...

I bought 2 gallons of 383 green CGI paint from Rapco to paint the humvee myself, but I changed my mind about painting it myself. Maaco said they could do it for $450. He said he’d have to ask a manager about using my paint, but ensured me they use Sherwin Williams and can match the color...

I have tried three different keyed ignitions on the HMMWV, and none of them have worked correctly. The first one I got from Federal military parts. I used a multi-meter and made sure the wires from the vehicle were labeled correctly (Battery, Ground, and Ignition). I wired them to the new...

Is there a trouble shooting section in the TM for the heater fan/blower, and if so could you tell me which manual and page number? I've been searching the TM's as well as the forums, and can't find it. When I toggle the heater fan switch to high or low nothing happens. I suspect it is a...

Has anyone bought or seen up close the Midwest Military Equipment Aluminum Hard Door kit for $2800? http://midwestmilitaryequipment.com/new-hummer-h1-military-998-humvee-hmmwv-aluminum-hard-door-kit-set-of-4/ I'm considering buying hard doors, I just don't know if these are worth the money...

How much paint should I buy to paint a humvee inside and out? Just doing solid green with black bumpers, etc. Rapcoparts.com has GCI for $40/gal. Which green color is recommended: CARC substitute or current issue lusterless Olive Drab, etc. ?

Found NOS for $40 using NSN. Tried to delete post. thanks

This is my first time replacing a fuel pump, so please bear with me. I am replacing the fuel pump in an m998 humvee according to TM20-2 (para 3-23 pg 3-36), and I did not order the gasket (8) that goes on the mounting plate (7). The youtube videos I watched did not remove the mounting plate...

Does anyone know a mechanic in Tulsa, OK that could check out a military HMMWV before I buy it? They guy has about six to choose from. Also, any recommendations for transporting it 120 miles. Thanks!!!

Does anyone know where to get a vacuum regulator valve for an '85 m1009 for a good price? It has to regulate vacuum to the modulator in the automatic transmission. The only ones I found were $350: Thanks in advance.

Any recommendations about mounting a spare tire on the front or brush guard of a M1009? Is the brush guard really strong enough to support a tire, and will it restrict radiator airflow too much, etc? I saw this M1008 with a spare on the brush guard...

Any recommendations about mounting a spare tire on the front or brush guard of a M1009? Is the brush guard really strong enough to support a tire, and will it restrict radiator airflow too much, etc? I saw this M1008 with a spare on the brush guard...

The little orange plastic piece that points to what gear the transmission is in is sitting just to the left of the Park "P" above the steering column. Is there a trick to fix it, or do you just pull the instrument panel and put it back in? Thanks in advance.

85 m1009 glow plug relay making muted buzzing / grinding noise. replaced it with new one and getting same noise. attached video with noise. any suggestions? thank you!