Recent content by dieselpony

Welcome to Steel Soldiers Forum! It is Warn No. 38826. Did you inspect the splinig on your axle shaft and hub housing? Often dirt/rust sits in there and prevent new parts from sliding in easily. Walter

Afaik the problems with the fuel filter base don't occur that sudden when the filter system was left untouched for quite a time (e.g. no filter change lately). Check the fuel lines and clamps from filter to injection pump. Look into the valley between the cylinders for wetness. Walter

same here - on alcoa style aluminium rims though. Walter

I had the exact same problem for years and never found out what caused the problem. In the beginning all worked like it should but after a filter change long time ago the lid didn't close completely. Buying another original Delco fiter didn't help. So i ended up turning the wing nuts down to...

Do the wipers stop but not return to park position when switched off, or don't they stop at all. In both cases it is mostly a problem with the electrical connections. Inspect both of the plugs on the wiper (2-prong and 3-prong). It is possible to open and clean them. Also make sure the ground...

Thanks for the clarification! I hoped so much that somebody would chime in on this subject! :jumpin: I bought my M1008 in Sep 1997 from a surpuls dealer here in germany. Maybe the truck left GL way before the modifications took place. Another one: I remember the voltmeter gauge. There are at...

From what I know the CUCV originally had modulators WITHOUT the adjusting screw. Can be replaced very easy though . . . Walter

Maybe there's a chance that the big rigs are using caps like that. Someone have to find out . . . Walter

Some more differences between years: - Motor oil withdrawel - Frame reinforcement (at least on the right frame near the exhaust manifold) Don't know for sure if this were true modifications. Walter

In opposite to lights, wipers etc. the horn is switched with the negative side. When pressing the horn button the circuit is grounded. I assume the diode is to not cause trouble with military parts like communication or radio equipment. Like the ones at the wiper motor or on the back of Gen 2...

The kit says Delco 37MT starter. Aren't our original starters the 27MT type? AFAIK: 27MT = direct drive 28MT = gear reduction Both available in 12 and 24v version. 37MT from the link is the direct drive, at least this is what the description says. :D Walter

And 14028931 for the earlier ( 1982-88 ) starters. Walter

It is a 8mm x 1.25 bolt, 20mm long with a 13mm head. Walter

x2 When i got my warn premiums for the D60, the installation sheet says NOT to pack the hubs in grease but to only light lube the assembly. Walter

If you are still using the automatic glow system, keep in mind that it was designed for "fast" glow plugs like the Wellman G70 or the Delco 13G. The AC 60G are "slow" self regulating glow plugs. If the truck won't start easy when cold, repeat glowing or, if not satisfied, change glow behaviour...